Infill

Support for UP BOX and UP BOX+. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
toto44
Posts: 27
Joined: Fri Dec 11, 2015 6:20 pm

Infill

Post by toto44 » Tue Oct 10, 2017 2:02 pm

infill.JPG
infill.JPG (302.36 KiB) Viewed 4047 times
Why is the lowest infill so strange! It does not give good surfaces.

User avatar
DrewPetitclerc
Posts: 581
Joined: Sat Feb 12, 2011 7:39 am
Location: Silicon Valley California
Contact:

Re: Infill

Post by DrewPetitclerc » Tue Oct 10, 2017 5:33 pm

Not enough cooling, is this PLA or ABS?
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc

toto44
Posts: 27
Joined: Fri Dec 11, 2015 6:20 pm

Re: Infill

Post by toto44 » Wed Oct 11, 2017 8:03 am

ABS. Well cooling is fixed on the UPBox. Should I reduce printing temperature?

Post Reply