I want to buy another 3D printer

How print better models
eyUP
Posts: 230
Joined: Thu May 24, 2012 3:23 pm

Re: I want to buy another 3D printer

Post by eyUP » Tue Aug 14, 2012 9:25 am

I can see them but I'm currently signed into Google and using Chrome...
I notice that the photo library is shown as "Visible to Limited"

juancr
Posts: 90
Joined: Sat Jul 28, 2012 10:19 am
Location: Spain
Contact:

Re: I want to buy another 3D printer

Post by juancr » Tue Aug 14, 2012 9:33 am

Sorry, I wanted to give access only by the link, but now they are public.
Regards,
JuanCR
(You should know I do my best with my written english ;-) )

juancr
Posts: 90
Joined: Sat Jul 28, 2012 10:19 am
Location: Spain
Contact:

Re: I want to buy another 3D printer

Post by juancr » Mon Aug 20, 2012 5:27 pm

Hello again to everybody.
After spending an ABS spool, I have to say that this printer is amazing for me: just prints and that's for I bought it for.
And today I have discovered that if you finish a spool while printing, you can put new filament without loosing the print, you only have to put the new filament into the extruder and it continues printing. Nice.
Very good quality, quite fast, low noise, you can print without being conneted to the computer... I'm in love with my UP (at this moment :mrgreen: )
Regards,
JuanCR
(You should know I do my best with my written english ;-) )

Locked