Page 1 of 1

UP! Mini Bed+ - An Improved Drop-In Heated Bed for the UP! M

Posted: Mon May 18, 2015 2:31 am
by upminicrazy
Hey Guys,

After getting repeatedly frustrated with prints lifting from the bed and having to always pre-heat, I designed my own custom bed for the UP! Mini. It has a higher maximum temperature of 80 degrees, heats up a lot faster, allows selection of the target temperature, and displays the current temperature. Furthermore it heats far more evenly, and hour-long preheats are no longer necessary. I've thrown it on Kickstarter in an attempt to manufacture a run of 100 of them for those who are interested:

https://www.kickstarter.com/projects/16 ... p-mini-bed

Re: UP! Mini Bed+ - An Improved Drop-In Heated Bed for the U

Posted: Sat Jun 06, 2015 12:01 am
by jeeplvr
Very nice project. Are the temperature setting switchable or wired?

Re: UP! Mini Bed+ - An Improved Drop-In Heated Bed for the U

Posted: Tue Jun 09, 2015 7:12 am
by Anatol
3 days left and only ~9% of the goal ;(

Re: UP! Mini Bed+ - An Improved Drop-In Heated Bed for the UP! M

Posted: Tue Jan 12, 2016 2:11 pm
by 3DSTB
I have searched i little bit and found the final product on this website:
http://3dprintingsystems.com/products/u ... heater-v2/

I just ordered one!!!

Re: UP! Mini Bed+ - An Improved Drop-In Heated Bed for the UP! M

Posted: Fri Jan 15, 2016 11:06 am
by brainzilla
"USD$89.00 + US$35"

They must be joking.
That's a $2,- PCB (at best).

Re: UP! Mini Bed+ - An Improved Drop-In Heated Bed for the UP! M

Posted: Fri Jan 15, 2016 2:35 pm
by steelmans
I wish I could buy one of these in the UK!!!