I have just purchased an Up! Mini and using the v1.18 Software and Platform calibration the front of the board is more than 1mm out. I have tried using the adjustment with the screw with spring (under the platform) but even with this it does not correct the front of the platform enough. I have already had to add an extra washer to the left hand side to even this out. Originally the left hand side of the board was >1mm out as well.
What are my options now?
Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
1 post • Page 1 of 1