Page 1 of 1

Motion system error y+

Posted: Wed Feb 21, 2018 6:03 am
by gmkado
Hello,

new to the forum but I've had an up mini for ~5 years now. I just started getting this error:
motion system error y+

The cause is obvious, the stage is running into the y-axis limit switch during the first layer of the print. I can't figure out why its trying to print there, the scale of the plastic it lays down looks way bigger than what is on the software print bed. I can't find a setting that would make this scale factor go wonky, hoping someone here has some insight.

Using software version 2.2.61.62

Thanks

Re: Motion system error y+

Posted: Mon Feb 26, 2018 12:00 am
by Tiertime-Elaine
Hi gmkado,

It sounds like something wrong with the hardware.

Please contact local Tiertime reseller or email us : support(at)tiertime.com


Elaine