Motion system error y+

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
gmkado
Posts: 2
Joined: Sat Sep 21, 2013 8:53 pm

Motion system error y+

Post by gmkado » Wed Feb 21, 2018 6:03 am

Hello,

new to the forum but I've had an up mini for ~5 years now. I just started getting this error:
motion system error y+

The cause is obvious, the stage is running into the y-axis limit switch during the first layer of the print. I can't figure out why its trying to print there, the scale of the plastic it lays down looks way bigger than what is on the software print bed. I can't find a setting that would make this scale factor go wonky, hoping someone here has some insight.

Using software version 2.2.61.62

Thanks

Tiertime-Elaine
Posts: 143
Joined: Wed Dec 20, 2017 4:23 am

Re: Motion system error y+

Post by Tiertime-Elaine » Mon Feb 26, 2018 12:00 am

Hi gmkado,

It sounds like something wrong with the hardware.

Please contact local Tiertime reseller or email us : support(at)tiertime.com


Elaine

Post Reply