New heating assembly thermistor bug

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
flagador
Posts: 3
Joined: Thu Oct 27, 2016 5:26 pm

New heating assembly thermistor bug

Post by flagador » Thu Oct 27, 2016 5:31 pm

Hi, I bought a heating assembly for my Up! mini on aliexpress and the software says the nozzle is at -5.5 ° c , it's obviously wrong because i touched it, even do' it's hot , i think it's not as hot as the original assembly . Because of this, i cant extrude and start any print, the printer waits until it's at 230°c so pleaaase help me ...

ricks01
Posts: 166
Joined: Wed Dec 30, 2015 6:07 pm

Re: New heating assembly thermistor bug

Post by ricks01 » Sun Oct 30, 2016 10:25 pm

You most likely have a break in a wire in your ribbon cable or a bad connection.

Post Reply