Page 1 of 1

[solved] Can I use 2.85 mm PLA instead of 1.75 mm

Posted: Sun Mar 13, 2016 12:59 pm
by tobih
Hello,
I've recently bought an up-mini. The manual says you must use 1.75 mm ABS/PLA.
Can I use 2.85 mm PLA from innofil or are chances high to damage the printer?
Thanks yor your help

Re: Can I use 2.85 mm PLA instead of 1.75 mm

Posted: Tue Mar 15, 2016 9:58 am
by Liova
It is impossible, it will not fit anywhere.

Re: Can I use 2.85 mm PLA instead of 1.75 mm

Posted: Tue Mar 15, 2016 1:48 pm
by Matchpoint
Ya it wont fit anywhere in the extruder at all. need to use 1.75mm

Re: Can I use 2.85 mm PLA instead of 1.75 mm

Posted: Thu Mar 17, 2016 6:49 pm
by tobih
Okay, thank you very much.