[solved] Can I use 2.85 mm PLA instead of 1.75 mm

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
tobih
Posts: 12
Joined: Sun Mar 13, 2016 12:57 pm

[solved] Can I use 2.85 mm PLA instead of 1.75 mm

Post by tobih » Sun Mar 13, 2016 12:59 pm

Hello,
I've recently bought an up-mini. The manual says you must use 1.75 mm ABS/PLA.
Can I use 2.85 mm PLA from innofil or are chances high to damage the printer?
Thanks yor your help
Last edited by tobih on Thu Mar 17, 2016 6:49 pm, edited 1 time in total.

Liova
Posts: 45
Joined: Wed Jun 10, 2015 8:03 am
Location: Moscow, Russia

Re: Can I use 2.85 mm PLA instead of 1.75 mm

Post by Liova » Tue Mar 15, 2016 9:58 am

It is impossible, it will not fit anywhere.

Matchpoint
Posts: 74
Joined: Tue Dec 15, 2015 10:50 pm

Re: Can I use 2.85 mm PLA instead of 1.75 mm

Post by Matchpoint » Tue Mar 15, 2016 1:48 pm

Ya it wont fit anywhere in the extruder at all. need to use 1.75mm

tobih
Posts: 12
Joined: Sun Mar 13, 2016 12:57 pm

Re: Can I use 2.85 mm PLA instead of 1.75 mm

Post by tobih » Thu Mar 17, 2016 6:49 pm

Okay, thank you very much.

Post Reply