My print bed mods - Bed and Temps

[mrgibbon]

Hi All, thought I would pass on my experiences with my Mini.

Firstly I'm using a glass print bed. One of these, slides right in, and although slightly longer, it hasn't caused an issue for me, just centre it on the platform.
http://www.ebay.com.au/itm/LearCNC-140x ... 0941255643
Im yet to figure out the best way to setup for raftless printing, I need a guide!

I have also added an 80 degree thermistor to help with bed temps, this seems to be doing a great job along with some blue painters tape.
Next mod will be a 60/80/100 degree switch for all print types.

This has helped enormously with my ABS prints, Im going to delve into PLA now and see if I can actually get my first print happening. (Clunk clunk clunk etc)

Cheers

[Stefan]

Glass bed looks pretty good.

What temps are you getting compared with the stock perf board?