Up Mini Extruder chip

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
User avatar
Numonic
Posts: 211
Joined: Thu Aug 16, 2012 12:11 am
Contact:

Up Mini Extruder chip

Post by Numonic » Fri Dec 11, 2015 3:42 pm

Hi does anyone out there have this chip or know whats going on with my extruder? I was printing out a replacement windbarrier and used Windbarrier V1.19.UP3
it worked perfectly. But after doing so my machine wont heat up or extrude.
Attachments
UpMiniChipIssue.jpg
UpMiniChipIssue.jpg (35.15 KiB) Viewed 4269 times

User avatar
Numonic
Posts: 211
Joined: Thu Aug 16, 2012 12:11 am
Contact:

Re: Up Mini Extruder chip

Post by Numonic » Fri Dec 11, 2015 4:46 pm

Got it to work again thank God :D must've been a lose wire or something took it apart several times and it worked again.

brainzilla
Posts: 141
Joined: Sat Nov 29, 2014 5:41 pm

Re: Up Mini Extruder chip

Post by brainzilla » Fri Dec 11, 2015 6:35 pm

It's just a segment of 12V LED-stripe.
You can buy those for a few bucks - in 5m rolls :-)

User avatar
Numonic
Posts: 211
Joined: Thu Aug 16, 2012 12:11 am
Contact:

Re: Up Mini Extruder chip

Post by Numonic » Fri Dec 11, 2015 6:40 pm

Thanks brainzilla i looked it up and found out. :lol:

Post Reply