Page 1 of 1

Printing issues and un-pausing a print job?

Posted: Sun Jul 19, 2015 7:22 pm
by Kharum
I have only had four successful prints with this printer and I am very close to putting it back in the box and selling it. Troubles I have had range from clogged print heads after two prints, getting nothing but stains of plastic all over the print table, and printed models being knocked over halfway through the print. I have taken to pausing the print just so I can apply super-glue around the base to hold it to the table. So my question about this two start printer is how do you un-pause a print job?

Re: Printing issues and un-pausing a print job?

Posted: Wed Jul 29, 2015 1:02 am
by mb20music
To "un-pause" a print you simply click on the "resume print" button.