UP Mini 3D Printer will not turn on

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
Driscoll3
Posts: 2
Joined: Thu Jun 25, 2015 6:18 pm

UP Mini 3D Printer will not turn on

Post by Driscoll3 » Thu Jun 25, 2015 9:32 pm

I have the UP! mini 3D printer. I accidentally left the printer on over the weekend, and when I attempted to print, the printer would not connect to the laptop. Both the power cord and the usb cable were fully connected. The printer would not turn off on its own, so I unplugged it and plugged it back in. The power button lit up blue and switched back to red. No matter what I did, the printer would not switch back to blue or beep three times like it usually does when it turns on. I unplugged and plugged it multiple times after that and received similar results. Finally, the light turned blue and stayed blue, but the computer would not recognize the usb connection. The printer has not made any of its usual starting up sounds. Please help.

mb20music
Posts: 375
Joined: Thu Feb 14, 2013 1:35 am
Location: USA

Re: UP Mini 3D Printer will not turn on

Post by mb20music » Thu Jun 25, 2015 11:57 pm

From what you are describing, it sounds to me like the CPU board has gone bad. If that is what the problem is, the CPU board is very expensive.
When did you purchase the printer? Are you still under warranty?

Driscoll3
Posts: 2
Joined: Thu Jun 25, 2015 6:18 pm

Re: UP Mini 3D Printer will not turn on

Post by Driscoll3 » Fri Jun 26, 2015 12:34 pm

The printer was purchased bout a month of so ago and should still be under warranty.

Post Reply