Small issues.... by printing

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
jacinek
Posts: 1
Joined: Sun Dec 28, 2014 11:33 am

Small issues.... by printing

Post by jacinek » Sun Dec 28, 2014 4:18 pm

Hi all...
Welcome everybody, i'm new in 3d printing world, but allready full involved :)
My first printer - UP! mini. So far i'm preety happy about it, with one small problem - like you can see on pictures,
my prints, espacially those liite bit bigger, are not good holded by raft, edges of my print are going up and raft is broken.
It makes that my prints are bit curved "from down".
What to do to change this situation ?
Material : ABS
Software / ROM / Firmware up to date.
Attachments
02.jpg
02.jpg (104.02 KiB) Viewed 5525 times
01b.jpg
01b.jpg (215.44 KiB) Viewed 5525 times

mb20music
Posts: 375
Joined: Thu Feb 14, 2013 1:35 am
Location: USA

Re: Small issues.... by printing

Post by mb20music » Mon Dec 29, 2014 4:23 am

Sounds to me like either you don't have your bed level, nozzle too far from the platform bed, or the air door on the extruder is open.

Also, the platform heater of the Mini doesn't get very hot, there is a mod that people have done to their Mini to rectify this. You can do a "search" for it.

Post Reply