Has anyone printed the Preassembled Secret Heart Box ?

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
ahntlia
Posts: 10
Joined: Fri Dec 27, 2013 3:48 am

Has anyone printed the Preassembled Secret Heart Box ?

Post by ahntlia » Sun Feb 09, 2014 7:25 am

Guys
I cant make this thing work
Tried shell and normal mode with only base option, but the top of the print fails

Is there any settings that work?

Also a far better explanation from the support parameters will be useful

I have reduced the angle to 10 degrees,
If I set the area to 0 mm2 should work as only base??

vvshukin
Posts: 2
Joined: Sun Feb 02, 2014 5:26 pm

Re: Has anyone printed the Preassembled Secret Heart Box ?

Post by vvshukin » Mon Feb 10, 2014 9:39 am

I had printed this thing with out-of-the-box parameters and fast quality and it was fine.

roller
Posts: 1622
Joined: Sat Oct 06, 2012 9:09 pm
Location: Brisbane, Australia

Re: Has anyone printed the Preassembled Secret Heart Box ?

Post by roller » Wed Feb 12, 2014 6:16 am

Link to the model you are talking about?


ahntlia
Posts: 10
Joined: Fri Dec 27, 2013 3:48 am

Re: Has anyone printed the Preassembled Secret Heart Box ?

Post by ahntlia » Mon Feb 17, 2014 4:54 pm

vvshukin wrote:I had printed this thing with out-of-the-box parameters and fast quality and it was fine.
Really?
My up fails to make the top section the overhang is just too big, I've also tried with out of the box parameters and the big problem is the support material trapped inside it makes impossible to dissasemble it and maek it work.
I tried with support only base and the top section simply not print...

vvshukin
Posts: 2
Joined: Sun Feb 02, 2014 5:26 pm

Re: Has anyone printed the Preassembled Secret Heart Box ?

Post by vvshukin » Mon Feb 24, 2014 3:02 pm

Yes the support was inside, i used knife to open it, but it was really hard.
It can easily break, so be careful.

Post Reply