Page 1 of 1

UP! mini Spool Shaft for RepRaper filament

Posted: Sat Dec 08, 2012 12:38 pm
by Poh
http://www.thingiverse.com/thing:37082

The original spool shaft for UP! mini is too short and wide to hold RepRapist filament. So I have to design a shaft my own in order to restore the peace.

And….hell, while the filaments from RapRaper has a very good quality, the printed support materials are almost impossible to remove! I blame the printer for having a fixed and non-customizable maximum print temperature at 270.

Re: UP! mini Spool Shaft for RepRaper filament

Posted: Sat Dec 08, 2012 6:14 pm
by ahd71
Nice shaft!

And for the fixed temperature...did you see my post earlier this week to overcome the limitation?

Re: UP! mini Spool Shaft for RepRaper filament

Posted: Tue Dec 11, 2012 5:46 am
by Form
Printed and used it yesterday.
Thank you

Re: UP! mini Spool Shaft for RepRaper filament

Posted: Thu Dec 13, 2012 4:23 am
by Poh
ahd71 wrote:Nice shaft!

And for the fixed temperature...did you see my post earlier this week to overcome the limitation?
Form wrote:Printed and used it yesterday.
Thank you
Thanks guys :)
I wanted to mod the heater, but i afraid it will void my warranty. I'll take an advise from you once the warranty is over ;)

Re: UP! mini Spool Shaft for RepRaper filament

Posted: Thu Dec 13, 2012 5:12 pm
by ahd71
Dont know if it voids the warantee in any way but its truly reverseble. In takes less than ten seconds to remove the mod and have it restored to its original state without a trace......