help, having problems getting started with up mini

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
a.baxter
Posts: 1
Joined: Sun Dec 08, 2013 3:43 pm

help, having problems getting started with up mini

Post by a.baxter » Sun Dec 08, 2013 4:03 pm

Hi, have been trying to get my new mini going, read through the manual following instructions about calibrating etc. went to do the test print and got message "printer system error layer 1" . it also stated" nozzle too cool", have followed all advice on this forum and none of the solutions seem to resolve the problem

Tiertime-Edward
Posts: 206
Joined: Tue Sep 07, 2010 9:15 am

Re: help, having problems getting started with up mini

Post by Tiertime-Edward » Mon Dec 09, 2013 1:35 am

Hi, please contact your vendor to replace the nozzle heater. I think it can solve your printer issue.

mb20music
Posts: 375
Joined: Thu Feb 14, 2013 1:35 am
Location: USA

Re: help, having problems getting started with up mini

Post by mb20music » Thu Dec 19, 2013 2:22 pm

Is the extruder heating up at all?

Post Reply