Still problems with 1 corner of my printbed

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
Rene1981
Posts: 16
Joined: Fri Nov 08, 2013 6:22 pm

Still problems with 1 corner of my printbed

Post by Rene1981 » Sat Nov 16, 2013 9:42 pm

Hello,

I get still problems with 1 corner of my printbed.
When i have to print in that corner, the filament is losing in that corner. (It comes up.)
In the other area, i don't have that problem, then my filament is fitting to my printbed.

Because of that problem, I can't print my callibration example, cause in that corner, the print is loose from the printbed and the print is an disaster.
What can I do to get just that corner a bit higher to my nozzle?

Thanks a lot!

Gr. René

ktronik
Posts: 96
Joined: Thu Apr 25, 2013 4:52 am

Re: Still problems with 1 corner of my printbed

Post by ktronik » Sun Nov 17, 2013 9:41 pm

Sounds like your print BED is NOT level, you need to check that it is level in the maintenance screen, by moving the head around and checking the height is the same, it will be lower where it lifts up, don't worry about printing the calibration example just yet, level your print bed first, and you will fix the issue...K

teamcarlisle
Posts: 180
Joined: Wed Jul 25, 2012 5:00 am

Re: Still problems with 1 corner of my printbed

Post by teamcarlisle » Mon Nov 18, 2013 5:54 am

Read the manual and mechanically level the bed first.

Rene1981
Posts: 16
Joined: Fri Nov 08, 2013 6:22 pm

Re: Still problems with 1 corner of my printbed

Post by Rene1981 » Mon Nov 18, 2013 8:05 am

ktronik wrote:Sounds like your print BED is NOT level, you need to check that it is level in the maintenance screen, by moving the head around and checking the height is the same, it will be lower where it lifts up, don't worry about printing the calibration example just yet, level your print bed first, and you will fix the issue...K
Hey,

thanks.
For levelling it is just put a corner higer? For example:
Nozzleheight mid = 131.51
Nozzleheight leftcorner = 131.91

Am I right thinking then?

ktronik
Posts: 96
Joined: Thu Apr 25, 2013 4:52 am

Re: Still problems with 1 corner of my printbed

Post by ktronik » Mon Nov 18, 2013 11:44 am

teamcarlisle wrote:Read the manual and mechanically level the bed first.
NO, mechanically level the bed first, via the little screws underneath.... only then use the cal platform function.

Rene1981
Posts: 16
Joined: Fri Nov 08, 2013 6:22 pm

Re: Still problems with 1 corner of my printbed

Post by Rene1981 » Sat Dec 28, 2013 10:51 am

Sorry for my late respons.

It worked with your answers.

Thanks for your help!

Gr. René

Post Reply