Page 1 of 1

Added a ProtoCycler to my collection

Posted: Wed Jan 07, 2015 11:32 pm
by caesar
I'm excited that I added a ProtoCycler to my collection of 3D printing stuff.
Specs look good at +/-0.02mm. Produced filament should work perfectly for all printers. It extrudes about 1kg in 2h and also spools it.
Shredder is good for failed prints, rafts and supports.

Can't wait to get it (although it will take some time)...

Re: Added a ProtoCycler to my collection

Posted: Thu Jan 08, 2015 7:14 am
by chang
Keep us updated when you receive it

Re: Added a ProtoCycler to my collection

Posted: Fri Jan 09, 2015 11:04 pm
by caesar
Will do for sure.
Being crowd-funded will take some time until I have it on my desk, can't wait though!