Talk about anything.
7 posts • Page 1 of 1
You are most likely not going to find a fan with the same connectors or wire length as the original fan, but you can just cut and solder the wires / connector to the new fan.OCSD3D wrote:It's a DC fan. The extruder fan on mine is a 40x40x10 fan. Easily purchased off amazon, ebay, or your local computer parts store.
You should be able to purchase the original fan from most any UP! or Afinia suppliers...
Which extruder is this on? If PLA it's the new 40x40x20 fan. I have 2 bad ones here. I've sourced an equivalent from farnell in the UK https://uk.farnell.com/ebm-papst/412h/f ... dp/1781433 and it seems much better so far.