UP! Mini Fan Connector

Talk about anything.
Post Reply
Tide
Posts: 7
Joined: Wed Oct 29, 2014 1:03 am

UP! Mini Fan Connector

Post by Tide » Fri Oct 31, 2014 5:02 am

Hi all:

Would anyone by any chance know the kind of JST connector used to connect the cooling fan to the extruder head? I know it is a 3-way JST but I am not sure if it is a PH or PA (or even a ZH).

Thank you.

Image

roller
Posts: 1622
Joined: Sat Oct 06, 2012 9:09 pm
Location: Brisbane, Australia

Re: UP! Mini Fan Connector

Post by roller » Fri Oct 31, 2014 12:17 pm

A search of "fan" and "JST" reveals the best answer to hand:

http://pp3dp.com/forum/viewtopic.php?f= ... it=jst+fan

or

http://www.pp3dp.com/forum/viewtopic.php?f=11&t=42955

The Mini, Plus and probably Cube too extruder assemblies are largely the same

:)

mb20music
Posts: 375
Joined: Thu Feb 14, 2013 1:35 am
Location: USA

Re: UP! Mini Fan Connector

Post by mb20music » Fri Oct 31, 2014 2:59 pm

They are definitely "EH" series connectors.

mb20music
Posts: 375
Joined: Thu Feb 14, 2013 1:35 am
Location: USA

Re: UP! Mini Fan Connector

Post by mb20music » Fri Oct 31, 2014 3:00 pm

They are definitely "EH" series connectors. I can say this without a doubt because I purchased some a few weeks ago.

http://www.digikey.com/product-search/e ... ageSize=25

Tide
Posts: 7
Joined: Wed Oct 29, 2014 1:03 am

Re: UP! Mini Fan Connector

Post by Tide » Sat Nov 01, 2014 11:17 pm

Thank you all!

This helps a lot as I'm in the process of modding the extruder head and adding one more cooling fan to it. :D

Post Reply