The Current State of 3D Printing

Talk about anything.
Post Reply
User avatar
DrewPetitclerc
Posts: 581
Joined: Sat Feb 12, 2011 7:39 am
Location: Silicon Valley California
Contact:

The Current State of 3D Printing

Post by DrewPetitclerc » Sun Jun 08, 2014 6:35 am

Hi All,

Wanted to put out to the community that I have been asked to be the guest speaker at the next "Silicon Valley Startup: Idea to IPO" event to be held here in the Bay area.
http://www.meetup.com/Silicon-Valley-St ... 186467962/

I'm humbled to be asked to talk about my experiences and my thoughts on where this might all be going.

I know it is very short notice and I'm not sure who lives close enough to want to attend but I wanted to let people know about it.

Regards
Drew
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc

amd-tec
Posts: 286
Joined: Sun Apr 15, 2012 6:16 am
Contact:

Re: The Current State of 3D Printing

Post by amd-tec » Sun Jun 08, 2014 8:14 am

Congrats,

would like to attend, but too far away ;).

Thanks,

amd-tec
"3D design with intelligent printing"
http://www.amd-tec.com

User avatar
josejuako
Posts: 479
Joined: Fri Aug 20, 2010 5:55 am

Re: The Current State of 3D Printing

Post by josejuako » Sun Jun 08, 2014 9:25 pm

Nice Drew !.



José

Post Reply