Page 1 of 1

Printing with rubber on Up! plus 2

Posted: Sun Jun 01, 2014 12:45 pm
by Rene1981
Hello,

does anyone tried printing with Rubber on the Up! plus 2?
If yes, can you please tell me how it works and what your experiences are with this filament?

Also, what kind of config do I have to use for this filament? And where did you buy your rubber filament?


Thanks a lot!

With kind regards,

René

Re: Printing with rubber on Up! plus 2

Posted: Mon Jun 02, 2014 2:12 am
by wilsonj
Hi Rene,

I've managed to print with Soft PLA on the standard extruder setup, but not much else I'm afraid. Certainly Filaflex or Ninjaflex won't print without modifications.