Total remote control 3d printing

Talk about anything.
Post Reply
ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Total remote control 3d printing

Post by ming » Mon May 19, 2014 2:09 pm

I will try my setup today - total remote control print

3dprinter is off and only perfboard on the bed.

Equipment / SW
1. 3dPrinter Ready to print (filament and bed ready)
2. WEMO switch (on/off power switch)
3. Team Viewer (remote control SW)
Attachments
webpage.jpg
webpage
webpage.jpg (46.84 KiB) Viewed 4731 times
rmtprn_set.jpg
Initial - ready
rmtprn_set.jpg (188.76 KiB) Viewed 4731 times
Dream@night / Holdit@sameday

ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Re: Total remote control 3d printing

Post by ming » Mon May 19, 2014 2:33 pm

Turn power on -WEMO switch
Start UP software
Initialize printer / heat up bed
UPload STL file and position part
{print}
Dream@night / Holdit@sameday

ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Re: Total remote control 3d printing

Post by ming » Mon May 19, 2014 4:17 pm

Print remote control process was a success but the printed part was too ambitous
at 1mm wall thickness i would assume it would be fine but my inexperience and ambitous proves otherwise

The funnel is salvageable by adding some epoxy and paint it outside but because we have the 3d print machine why not just change it to thicker wall :)
funnel2_z1.jpg
funnel2_z1.jpg (76.45 KiB) Viewed 4724 times
funnel2.jpg
funnel2.jpg (156.81 KiB) Viewed 4724 times
Dream@night / Holdit@sameday

ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Re: Total remote control 3d printing

Post by ming » Mon May 19, 2014 4:31 pm

Before and after wall thickness increase
Attachments
thckerwall.jpg
before after :)
thckerwall.jpg (23.1 KiB) Viewed 4723 times
Dream@night / Holdit@sameday

Post Reply