calibration print

Talk about anything.
Post Reply
ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

calibration print

Post by ming » Tue Mar 25, 2014 10:08 pm

i just played with a calibration print ( just made it and printing on glass to check if i need any adjustments to my setup of heights or levelling

Please recommend what i should include in a calibration print and i can provide the STL ot part file (solidworks) for sharing

Image

as it was printing layer 10 it lifted up with 0.25mm off the glass as nozzle height
may have to lower it to 0.15 and try again
Image
Dream@night / Holdit@sameday

ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Re: calibration print

Post by ming » Tue Mar 25, 2014 11:08 pm

layer 20+ with 21 minutes left from the software says "printed disconnected " which now i have to restart the software
and its now displaying all the ergular info So im not sure why it says disconnected

so far so good i put an halogen lamp to it so it warms up the area a tad as the house its kinda cold today 65 F or so
Image
Dream@night / Holdit@sameday

Post Reply