Page 1 of 1

Type of connector used on extruder fan?

Posted: Fri Jan 31, 2014 7:42 pm
by goopyplastic
Anyone know what type of connector is used on the extruder fan?

Thanks!

Re: Type of connector used on extruder fan?

Posted: Fri Jan 31, 2014 10:54 pm
by twocycler
It's a JST XH 3P connector.

Re: Type of connector used on extruder fan?

Posted: Sat Feb 01, 2014 1:04 am
by goopyplastic
I believe XH is for the heater / thermocouple and the fan connector is smaller.

Re: Type of connector used on extruder fan?

Posted: Sat Feb 01, 2014 1:53 am
by roller
goopyplastic wrote:I believe XH is for the heater / thermocouple and the fan connector is smaller.
From memory (i'm out and about) they are all JST XH just the fan is 3P (3pin) as twocycler pointed out and the temp/heater is 4P (4pin)

Re: Type of connector used on extruder fan?

Posted: Tue Feb 04, 2014 7:30 am
by goopyplastic
Is it possible that the Afinia has a different connector for fan? I would think they would be the same, here you can see the connector:

http://imgur.com/a/uys53

Definitely smaller than the XH connector next to it.