Base Support to small

Talk about anything.
Post Reply
Darkparasit
Posts: 2
Joined: Sun Nov 17, 2013 8:29 pm

Base Support to small

Post by Darkparasit » Sun Nov 17, 2013 8:35 pm

Hello,

I have a problem to print objects like a dog for example. the problem is that the support is to small in the exmaple of the dog the printer does 4 support structures for each leg. Later in printing (before the legs are attached to the body) in about 80% of the prints one or more leg fall because the support does not stick to the platform.
Is it possible to force the support to be bigger? For example one only support for all 4 legs?

Thanks you

Thomas

Carnivore
Posts: 113
Joined: Thu Oct 17, 2013 8:38 pm

Re: Base Support to small

Post by Carnivore » Mon Nov 18, 2013 3:44 pm

Increase the angle of support from 30 to 80

Sent from my SAMSUNG-SGH-I317 using Tapatalk 2

Darkparasit
Posts: 2
Joined: Sun Nov 17, 2013 8:29 pm

Re: Base Support to small

Post by Darkparasit » Tue Nov 19, 2013 3:46 pm

Thank you! dident knew that is parameter is for base support :)

Carnivore
Posts: 113
Joined: Thu Oct 17, 2013 8:38 pm

Re: Base Support to small

Post by Carnivore » Tue Nov 19, 2013 4:38 pm

It's in setup.

Post Reply