First impressions Afinia VS Cubify

Talk about anything.
Posts: 113
Joined: Sat Dec 29, 2012 6:59 pm

Re: First impressions Afinia VS Cubify

Post by Robin » Wed Sep 11, 2013 6:57 pm

Talking about, "not correctly recalling the parameters", I have been having problems calibrating the table height.
I must have missed the screams about "Tools/Print Again" using the original print height rather than the new because I had to figure it out for myself.
When recalibrating the table following a nozzle crash do not think you can get away without totally resending each and every layer.
Shame it doesn't save that "Heat the table after the print" setting which might actually be useful :roll:

User avatar
Posts: 667
Joined: Fri Nov 12, 2010 5:46 am

Re: First impressions Afinia VS Cubify

Post by wackojacko » Thu Sep 12, 2013 9:55 pm

This is how not to have the feeder straw setup while printing

Need help with your printer, check out our Youtube channel. ... /playlists

Post Reply