Turn off support

Talk about anything.
Post Reply
Tiertime-Edward
Posts: 206
Joined: Tue Sep 07, 2010 9:15 am

Turn off support

Post by Tiertime-Edward » Thu Aug 01, 2013 8:04 am

Did you find new features in UP 2.0? One of some is you can start to turn off support complete by select ONLY BASE in print parameter -> Support -> Area -> ONLY BASE.
Attachments
turn off support.jpg
turn off support.jpg (33.98 KiB) Viewed 5626 times

User avatar
wilsonj
Posts: 569
Joined: Tue Feb 28, 2012 10:26 pm
Location: Australia

Re: Turn off support

Post by wilsonj » Thu Aug 01, 2013 9:54 am

Hi Edward,

Yes I did see that, although I haven't tried it. So finally we can print whistles !!!

Great work!
Regards
Jamie
3DPrinterGear.com.au

roller
Posts: 1622
Joined: Sat Oct 06, 2012 9:09 pm
Location: Brisbane, Australia

Re: Turn off support

Post by roller » Thu Aug 01, 2013 11:14 am

wilsonj wrote: Yes I did see that, although I haven't tried it. So finally we can print whistles !!!

Great work!
If our bridging is good enough ... fingers crossed!

amd-tec
Posts: 286
Joined: Sun Apr 15, 2012 6:16 am
Contact:

Re: Turn off support

Post by amd-tec » Thu Aug 01, 2013 8:31 pm

Edward wrote:Did you find new features in UP 2.0? One of some is you can start to turn off support complete by select ONLY BASE in print parameter -> Support -> Area -> ONLY BASE.
Is it working in older machines which use 2.0 software?
I didn`t find that option in my machine (I`m using 2.0 software).
"3D design with intelligent printing"
http://www.amd-tec.com

LonV
Posts: 220
Joined: Thu Nov 15, 2012 11:53 pm
Location: Phoenix, Arizona, USA

Re: Turn off support

Post by LonV » Fri Aug 02, 2013 5:06 am

Haha, I was sure this would print fine on my reprap first pass...and not even come close on my Afinia (Up! Plus). :P I was wrong.

Reprap was a mess (currently trying some other settings)...Afinia printed perfectly (Normal speed, .15 layer height, dense fill).
Attachments
photo 3.jpg
photo 3.jpg (244.83 KiB) Viewed 5543 times
photo 2.jpg
Top view (perfect, no sagging that I can see...even in the whistle opening)
photo 2.jpg (127.55 KiB) Viewed 5543 times
photo 1.JPG
Bottom view (part that was touching raft)
photo 1.JPG (241.33 KiB) Viewed 5544 times

amd-tec
Posts: 286
Joined: Sun Apr 15, 2012 6:16 am
Contact:

Re: Turn off support

Post by amd-tec » Fri Aug 02, 2013 6:28 am

amd-tec wrote:
Edward wrote:Did you find new features in UP 2.0? One of some is you can start to turn off support complete by select ONLY BASE in print parameter -> Support -> Area -> ONLY BASE.
Is it working in older machines which use 2.0 software?
I didn`t find that option in my machine (I`m using 2.0 software).
Forget the previuos..., I was looking from the wrong folder.
"3D design with intelligent printing"
http://www.amd-tec.com

Post Reply