Search found 5 matches

by bobjohn1
Fri Sep 06, 2013 6:47 pm
Forum: UP Plus
Topic: Difficult/impossible raft separation when using PLA
Replies: 5
Views: 4733

Difficult/impossible raft separation when using PLA

Using the ABS filament that came with the printer it is AMAZINGLY easy to remove the part from the raft, but when I try to use my PLA, the prints have to be cut off of the raft. In addition to this, there is some nasty spider-webbing that I can't seem to get to go away. Is this just the way it is wi...
by bobjohn1
Mon Sep 02, 2013 4:07 am
Forum: General Discussion
Topic: Thinking about UP..
Replies: 11
Views: 8092

Re: Thinking about UP..

I've asked this a couple other places, but how do I print without supports in v2.0 of the software?
by bobjohn1
Sun Sep 01, 2013 8:50 pm
Forum: General Discussion
Topic: How to print without support?
Replies: 3
Views: 5457

How to print without support?

I have the UP Plus 2 and am trying to print this fan duct , but it keeps filling in the duct interior with support, which becomes impossible to remove. I'm also running into the same issue when printing LEGO bricks. I can't figure out how to turn off the support. Any help? The documentation isn't re...
by bobjohn1
Sun Sep 01, 2013 8:03 pm
Forum: UP Software
Topic: How do I turn off support?
Replies: 6
Views: 5759

Re: How do I turn off support?

Nope, that didn't do it. This is the fan duct I'm trying to print off: http://www.thingiverse.com/thing:138893
by bobjohn1
Fri Aug 30, 2013 9:02 pm
Forum: UP Software
Topic: How do I turn off support?
Replies: 6
Views: 5759

How do I turn off support?

Simple question, I'm hoping it's a simple answer. How do I turn off support? I'm printing a fan duct, so it's nearly impossible to remove the supports that are created on the interior of the duct. Any suggestions? I've tried searching the messageboard already, but it tells me that "turn off support"...