Search found 5 matches

by termsl
Thu Feb 20, 2014 5:00 pm
Forum: UP Plus
Topic: Temperature error
Replies: 4
Views: 4299

Re: Temperature error

or your Up is sitting in the snow - hahah)))) I was upgrade all of this, turn off/on many times, re-init printer, try to do anything from another computer - not result. The situation does not change :( I think this is a hardware problem. The electrical circuit of the printer would be perfect, but i...
by termsl
Thu Feb 20, 2014 4:59 pm
Forum: UP Plus
Topic: Temperature error
Replies: 4
Views: 4299

Re: Temperature error

Does it shows these temperatures while warming up. Earlier versions of software show negative temperatures once the print actually starts, but these are meaningless. cheers Peter Hi Peter! No, any time (i waited for temp reach point 270 Celsius and power off the printer) reading value of temperatur...
by termsl
Mon Feb 17, 2014 6:49 pm
Forum: UP Plus
Topic: Extruder Temp Read Error
Replies: 8
Views: 9525

Re: Extruder Temp Read Error

Hi Changfrancis!

Do you fix the issue?
I have a similar problem...
by termsl
Mon Feb 17, 2014 6:38 pm
Forum: UP Plus
Topic: Temperature error
Replies: 4
Views: 4299

Temperature error

Hi !
In last printing something do wrong and printer was stop.
After restart printer shows "minus" temp both on platform and extruder:
Image

Extruder heater is 7.5 ohm and thermistor is 118 ohm, can I fix it myself?
by termsl
Mon Dec 10, 2012 11:44 am
Forum: General Discussion
Topic: Knocking from UP Printer
Replies: 22
Views: 19193

Re: Knocking from UP Printer

I decided the problem first so-warmed nozzle and took it off. After the gas burner heat it and cleaned it inside the remnants of plastic warming burner at times. Then thin wire cleared the hole and set the nozzle back. But the problem came back after 15 minutes, and I just started printing and hands...