stepper motor failing to turn the gear

Share your experience with UP BOX and UP BOX+
Post Reply
Joined:Mon Mar 18, 2019 1:55 am
stepper motor failing to turn the gear

Post by Andy3D » Wed May 01, 2019 2:12 am

My UpBox+ has suddenly failed. Overnight it started airprinting mid-print. This morning I retracted the filament and cut it off, and then tried to extrude again, and found that the filament wasnt being pulled in. So I stripped it down and cleaned the gears with a toothbrush (was some plastic dust, but nothing major). The problem seems to be that the gearwheel isnt spinning - it IS powered, but just kind of stutters in place. What would cause this, and is there a fix? Im in the middle of large job and really need this machine operational :(
Thanks for any tips,

Joined:Tue Oct 16, 2018 8:25 am

Re: stepper motor failing to turn the gear

Post by TiertimeBrook » Sun May 05, 2019 7:34 am

Hi Andy,

Try to replug the extruder cable , especialy the end that connected with the extruder back PCB, It usually become loosing when the extruder moving.

Wish that will help. if not ,then you can contact our support team by email.


Post Reply