Thin wall delamination?

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Tue Dec 25, 2012 7:52 am
Thin wall delamination?

Post by cj7hawk » Fri Nov 16, 2018 9:07 am

Hi All,

Just wondering if there's a way to correct for the amount of fill in a model - I'm finding that at under 2mm, the wall infill doesn't work so well and doesn't bond to the sides.

As a result, these walls are a sandwich of two thin external walls and whatever fill going into the middle, and these walls often delaminate and split.

Is there a way to correct for this?


Post Reply