[Feature Request]

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Fri May 15, 2015 7:55 pm
[Feature Request]

Post by Xonor13 » Sun Dec 27, 2015 9:35 pm

1. A simple request to make it possible for the printer to wipe the nozzle longer before a new print so it gets ALL of the plastic off, and maybe have the nozzle change directions because when it normally wipes the nozzle all of the plastic builds up on the one end.

2. Could you also have the software make the printer move to the front left corner and have the build plate put to the bottom before every print so before it prints the material can "drip" out of the nozzle more without clumping up and it helps wipe off of the nozzle.

Any of these minor improvements would be greatly appreciated.

Post Reply