Hi does anyone out there have this chip or know whats going on with my extruder? I was printing out a replacement windbarrier and used Windbarrier V1.19.UP3
it worked perfectly. But after doing so my machine wont heat up or extrude.
Up Mini Extruder chip
- Attachments
-
- UpMiniChipIssue.jpg (35.15KiB)Viewed 5922 times
Re: Up Mini Extruder chip
Got it to work again thank God
must've been a lose wire or something took it apart several times and it worked again.

-
- Posts:141
- Joined:Sat Nov 29, 2014 5:41 pm
Re: Up Mini Extruder chip
It's just a segment of 12V LED-stripe.
You can buy those for a few bucks - in 5m rolls
You can buy those for a few bucks - in 5m rolls

Re: Up Mini Extruder chip
Thanks brainzilla i looked it up and found out. 
