Try Gyroid Zonohedron!

[jspark]

Hi~

Now, I'm tring to print the Gyroid Zonohedron lamp shade created by dizingof!
http://www.thingiverse.com/thing:20392

I think It's a so beautiful structure!

I used 30deg, stable support, clear filament.

The running time is over 1day!!!

The clear filament not that much clear than that of I expected.

I hope It's gonna be safe!

[wilsonj]

Looks great. Please show the zono when done. Perhaps put a light in the bottom.

[jspark]

Yes, I will!
But I have no idea how I can remove that complex supports!!

[wackojacko]

To get the filament as clear as possible print at 0.2mm fine. Also use the v7 or plus wind barrier.

www.3DPrintingSystems.com

[jspark]

Hi!
Finally I got it!
Thanks wacojacko! But its a 0.2mm, and I'm using now the v7 wind barrier.
The filament is normal ABS which is made in korea.
The surpport removing work was over 1 hour!
And there was 2 times of pause printing for support repairing.
It's a really beautifule structure. Thanks dizingof!!

Gyroid Zonohedron Lamp Shade made by clean ABS

jspark_Gyroid Zonohedron Lamp Shade_20120830.jpg (157.76 KiB) Viewed 10460 times

[wilsonj]

Lovely prints. That's a great shade of blue too !

[eyUP]

Really nice !

[juancr]

Wonderful.
Dizingof is a "monster" .
And take a look in this people and their software:
http://www.thingiverse.com/nervoussystem
http://n-e-r-v-o-u-s.com/cellCycle/

[jspark]

Always thanks wilsonj and eyUP!

Wow! He is an another monster!
Thanks juancr for cool information!