But iam running in the most annoying issues with the print head jamming all the time.
The filament always break that way.
I tried different filament including a new spool that was still air tight.
Iam not even trying to print anything, it is jamming while just extruding in the maintenance tab.
I cleaned the print head the best i could, but still, .. iam running into a wall here.
To me it look like the mechanical wheel inside the head doesnt have enough grip on the filament.
Please le me know if you have any suggestions ...
I had a similar issue with my first motor. Not sure what caused it, but it's likely that starting my prints too close to the bed caused it to 'click' and eventually wear out the teeth.
It was less than a year old and replaced under warranty, and it's been working great since.
Not sure where I can could find this piece...
Do you have a local vendor?
Have a look on Tiertimes site for resellers by region - https://www.tiertime.com/regional-resellers/
Is it possible that it comes from some dirt in the melting canal ? i have try my best to clean it, but i would be curious to know how you guys handle that ?
for a time i thought the filament was getting stuck somehow in the Teflon tube, so i hang the wheel on top. But that does not help...
my prints always failed mid way ...
would is be possible that my head is dirty ? should i soak the metal parts in acetone ?
I tried so many thing to try to fix this, i feel like iam running our of ideas...