stainless steel nozzles

Matchpoint · Post by **Matchpoint** » Thu Feb 25, 2016 4:02 pm

anyone know of any non-brass nozzles that fit the up hot end

tegregg · Post by **tegregg** » Fri Feb 26, 2016 2:47 am

I was told last time I ordered a nozzle that the Up Box came with different colour nozzles on different machines. They had silver and bronze coloured ones there at the time so I assume the silver ones may be stainless steel.

Link to the store
http://3dprintersuperstore.com.au/

Oland · Post by **Oland** » Wed Mar 02, 2016 12:10 pm

http://www.banggood.com/0_4MM-Stainless ... 12193.html

The inner bore is too small for the UP mini-extruder, so drilled to 3.5mm
outside is ok (M6)
I want to use formfutura 1.75mm "CarbonFil" they recommend SS nozzle

Kai · Post by **Kai** » Mon Apr 18, 2016 7:49 pm

I use one from Micro-Swiss. This nozzle has a brass core and is hard plated with TwinClad XT:
https://store.micro-swiss.com/collectio ... rtrax-m200

From the reading it appears that the Zortrax M200 uses the same nozzles.

car3less · Post by **car3less** » Wed Apr 20, 2016 9:17 am

Kai wrote:I use one from Micro-Swiss. This nozzle has a brass core and is hard plated with TwinClad XT:
https://store.micro-swiss.com/collectio ... rtrax-m200

From the reading it appears that the Zortrax M200 uses the same nozzles.

And does it work well?

I have in the office Up plus 2, Up Box and Zortrax so this nozzle would be great for all of them.
For me, from Formfutura only one type of PLA works on Up and no ABS. Didn't even bother to try Carbonfill...

Kai · Post by **Kai** » Fri Sep 23, 2016 10:09 pm

The Twin Clad Micro Swiss Nozzle works very well, even after printing some kilograms ofAlu ABS

stainless steel nozzles

Re: stainless steel nozzles

Re: stainless steel nozzles

Re: stainless steel nozzles

Re: stainless steel nozzles

Re: stainless steel nozzles