stainless steel nozzles
-
- Posts:74
- Joined:Tue Dec 15, 2015 10:50 pm
anyone know of any non-brass nozzles that fit the up hot end
Re: stainless steel nozzles
I was told last time I ordered a nozzle that the Up Box came with different colour nozzles on different machines. They had silver and bronze coloured ones there at the time so I assume the silver ones may be stainless steel.
Link to the store
http://3dprintersuperstore.com.au/
Link to the store
http://3dprintersuperstore.com.au/
Re: stainless steel nozzles
http://www.banggood.com/0_4MM-Stainless ... 12193.html
The inner bore is too small for the UP mini-extruder, so drilled to 3.5mm
outside is ok (M6)
I want to use formfutura 1.75mm "CarbonFil" they recommend SS nozzle
The inner bore is too small for the UP mini-extruder, so drilled to 3.5mm
outside is ok (M6)
I want to use formfutura 1.75mm "CarbonFil" they recommend SS nozzle
Re: stainless steel nozzles
I use one from Micro-Swiss. This nozzle has a brass core and is hard plated with TwinClad XT:
https://store.micro-swiss.com/collectio ... rtrax-m200
From the reading it appears that the Zortrax M200 uses the same nozzles.
https://store.micro-swiss.com/collectio ... rtrax-m200
From the reading it appears that the Zortrax M200 uses the same nozzles.
Re: stainless steel nozzles
Kai wrote:I use one from Micro-Swiss. This nozzle has a brass core and is hard plated with TwinClad XT:
https://store.micro-swiss.com/collectio ... rtrax-m200
From the reading it appears that the Zortrax M200 uses the same nozzles.
And does it work well?
I have in the office Up plus 2, Up Box and Zortrax so this nozzle would be great for all of them.
For me, from Formfutura only one type of PLA works on Up and no ABS. Didn't even bother to try Carbonfill...
Re: stainless steel nozzles
The Twin Clad Micro Swiss Nozzle works very well, even after printing some kilograms ofAlu ABS 
