Up Mini Extruder chip

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
User avatar
Numonic
Posts:211
Joined:Thu Aug 16, 2012 12:11 am
Contact:
Up Mini Extruder chip

Post by Numonic » Fri Dec 11, 2015 3:42 pm

Hi does anyone out there have this chip or know whats going on with my extruder? I was printing out a replacement windbarrier and used Windbarrier V1.19.UP3
it worked perfectly. But after doing so my machine wont heat up or extrude.
Attachments
UpMiniChipIssue.jpg
UpMiniChipIssue.jpg (35.15KiB)Viewed 5924 times

User avatar
Numonic
Posts:211
Joined:Thu Aug 16, 2012 12:11 am
Contact:

Re: Up Mini Extruder chip

Post by Numonic » Fri Dec 11, 2015 4:46 pm

Got it to work again thank God :D must've been a lose wire or something took it apart several times and it worked again.

brainzilla
Posts:141
Joined:Sat Nov 29, 2014 5:41 pm

Re: Up Mini Extruder chip

Post by brainzilla » Fri Dec 11, 2015 6:35 pm

It's just a segment of 12V LED-stripe.
You can buy those for a few bucks - in 5m rolls :-)

User avatar
Numonic
Posts:211
Joined:Thu Aug 16, 2012 12:11 am
Contact:

Re: Up Mini Extruder chip

Post by Numonic » Fri Dec 11, 2015 6:40 pm

Thanks brainzilla i looked it up and found out. :lol:

Post Reply