[BUG REPORT] stringing

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Nick Rouse
Joined:Fri Aug 30, 2013 10:47 am
[BUG REPORT] stringing

Post by Nick Rouse » Fri Aug 30, 2013 11:15 am

I have just loaded version 2 and have a minor problem with a component that printed cleanly several times with version 1.8
The component has a flat base with a circular hole in it. Vertical walls rise up around this interior hole. The edge where the base meets the walls is rounded with a 2 mm radius.
With the new software, in forming this curve, about a half a millimeter up from the base surface, the printer strings threads in a straight line through the air from one part of the curve to another
further around the curve. The old software did not do this.

Post Reply