Longest one load print

Coffee place for all the Uppers. Discuss about UP techniques, sharing ideas and tips. Coffee is on the house. :)
Post Reply
Posts: 7
Joined: Tue Dec 04, 2012 1:32 pm

Longest one load print

Post by Liutauras » Wed Mar 13, 2013 12:45 pm

What is your longest, one load, successful print? Mine, with UP!Plus, was 22 hours and 16 minutes. 0.15 layers, loose, with raft, 150.9g of material. Right after that Plus made second one 22 hours print, same options, 149.6g material usage. 8-)
uplong.JPG (57.71 KiB) Viewed 5790 times

Posts: 10
Joined: Sat Feb 16, 2013 6:29 pm

Re: Longest one load print

Post by Marbla » Fri Mar 22, 2013 5:10 pm

Mine was probably the Airship: ( http://www.thingiverse.com/thing:45295 ). I think I printed one or two halves and other pieces. I remember printing sometin more for it but I don't remember which piece. It took a little over 9 hours on 0.15, Fine.

I also wanted to print the Voronoi Yoda: ( http://www.thingiverse.com/thing:44505 ) as one of my first prints but it was supposed to take 33 hours. It's probably because the support setting were on everything and I'm still scared to risk the time for failure.

Speaking of which, has anyone managed to print the Voronoi Yoda on the UP! Plus? What settings did you use?

Post Reply