Raft Adhesion Setting [Feature Request]

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Sat Oct 06, 2012 9:09 pm
Location:Brisbane, Australia
Raft Adhesion Setting [Feature Request]

Post by roller » Tue Jan 15, 2013 12:27 am

I am finding with version 1.4 (1.18) that raft removal is extremely easy but with some prints, which don't join the raft over a significant area (shell prints), I have found I am losing them because they break free from the raft while printing. It would be nice if there was an option in setup to have some more adhesion on the raft for some prints, especially those with a low base surface area or inclined to warp.

Post Reply