MKIII + laser engraver?

Share your experience with Cetus. You can also visit www.cetus3d.com
Post Reply
telarium
Posts: 2
Joined: Mon Mar 25, 2019 6:43 pm

MKIII + laser engraver?

Post by telarium » Mon Mar 25, 2019 6:43 pm

Does the MKIII extension board have support for a laser engraver in addition to the auto-level probe and the heated bed?

Arnold
Posts: 3
Joined: Fri Mar 08, 2019 3:34 pm

Re: MKIII + laser engraver?

Post by Arnold » Mon May 06, 2019 6:18 am

I documented the Extension Board

SKU: BC0860

Pz (yellow, 2 pins) - connects to Z axis endstop
Py (red, 2 pins) - connects to Y axis endstop
Pinit2 (blue, 2 pins) - connects to calibration probe
Pw2-main (white, 10-pin ribbon) - connects to main board
Pdb-1 (white, 20-pin ribbon) - connects to the heated bed
CON2 - connects to the 220W power brick
J1 - connects power to the main board
PYI (red, 4 pins) -
PYO (red, 4 pins) -
PZI (no connector) -
PZO (no connector) -
KG1 (no connector) -

As you can see, there are still some available but only Tiertime knows what they're for.

Post Reply