First 3 layers are thicker

Share your experience with Cetus. You can also visit www.cetus3d.com
Post Reply
skatman
Posts: 1
Joined: Thu Oct 18, 2018 4:40 pm

First 3 layers are thicker

Post by skatman » Fri Nov 23, 2018 5:20 pm

Hi,

Have a Cetus 3D MK II, using UPstudio.

Printing without raft, with 0.4 nozzle and 0.2 layer height.
All my print have first 3 layers visibly thicker. This add up ~0.5 mm of Z height all the time. Maybe someone found how to solve this problem?

Thank you in advance.

TiertimeBrook
Posts: 36
Joined: Tue Oct 16, 2018 8:25 am

Re: First 3 layers are thicker

Post by TiertimeBrook » Wed Nov 28, 2018 6:23 am

Hi
Printing without raft may cause this issues because when the build plate not be leveled well, the first layers will make a compasation on the different point to make sure the leveling of the whole prints, So You'd better print with raft for a better prints .

Regards
Brook

Zardal
Posts: 1
Joined: Wed Jul 11, 2018 1:57 pm

Re: First 3 layers are thicker

Post by Zardal » Mon Dec 10, 2018 12:02 pm

TiertimeBrook wrote:
Wed Nov 28, 2018 6:23 am
Hi
Printing without raft may cause this issues because when the build plate not be leveled well, the first layers will make a compasation on the different point to make sure the leveling of the whole prints, So You'd better print with raft for a better prints .

Regards
Brook
Thank you for this answer, I had the same issue!

Post Reply