Share your experience with UP300!
5 posts •Page 1 of 1
I think you completely missed the point.Tiertime_Ocean wrote: ↑Thu May 09, 2019 4:09 amDear Customer,
UP 300 is 3D printer so can't recognized as memory when connect to computer.
You can send task to UP 300 via UP Studio.
Please refer UP 300 user manual.
Please feel free to contact us if you have any problems. email@example.com
We're not trying to use the printer as memory - we just want to be able to edit the queue. That is quite possible via every interface the printer has, and even if it wasn't, we're only talking software changes, so it would be. I think the correct term is "Tiertime doesn't support it", but we'd really like it if you could consider this change.
As for the manual, that doesn't describe how to do this in UP Studio, which doesn't seem to have the capability you suggest it does.
Finally, the feature in firmware "Clear" doesn't actually work. Seriously. It's broken. It's been broken in EVERY version since launch. Fixing this in firmware would be great - I suspect no one at the factory has noticed, because it's only a problem when you print a lot of stuff.