Just tried the default 100% Fill on a model with default settings, 0.1mm layers.
The outer will is still not attached to the infill, with the worst affect being on the right rear side ( that is, the right side, or rear side, will show the worst separation between the wall and the fill, or in a circle, the right, rear side of the print. )
Is anyone from Tiertime able to confirm that you're aware of the problem? It seems to be affecting 100% of your users presently.
Thanks
David.
[Bug Report] Wall still not attached to infill 19th March 2019 firmware.
Re: [Bug Report] Wall still not attached to infill 19th March 2019 firmware.
File that generates the test shape;
- Attachments
-
- 3mm square box test for walls.zip
- (425Bytes)Downloaded 98 times
-
- Posts:9
- Joined:Thu Mar 14, 2019 1:40 pm
Re: [Bug Report] Wall still not attached to infill 19th March 2019 firmware.
Downgrade to software 2.5.x solve the problem!
Re: [Bug Report] Wall still not attached to infill 19th March 2019 firmware.
What is the board firmware to support this? Now I've upgraded it, it just errors out when I try to run 2.5.x -
I'm not sure it's safe to downgrade after the recent string of firmware failure updates, especially as I'm on the latest.

I'm not sure it's safe to downgrade after the recent string of firmware failure updates, especially as I'm on the latest.
