[Bug Report] Can't use external Gcode

Support for UP300. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
BigE79
Posts:43
Joined:Fri Oct 26, 2018 9:18 pm
[Bug Report] Can't use external Gcode

Post by BigE79 » Sat Mar 16, 2019 9:21 pm

Hello Tiertime,

When following the "UP Studio G-code Tutorial.pdf" instruction I can't the printer to start print. Step 8 of the instruction simply states to "add the Cgode into Up Studio". When I try this I first get the warning: "Run File: *.GCODE? Warning: Improperly formatted G-code may damage the printer"
This in fine but when I select 'Yes' I just get an error:
Up Fail.PNG
Up Fail.PNG (3.89KiB)Viewed 2491 times
The error code is not always the same but it always says "Failed to start (CTRL)"
I'm not the only one having this issue see thread: viewtopic.php?f=48&t=56592&sid=f3b79c54 ... 0beb8bf3e9

Can you please give further instruction on how to get this to work or release a software fix?
I was sold my printer with the promise it would support external g-code.

Post Reply