Page 1 of 1

Nozzle not heating on prints - but can extrude in the tool box

Posted: Tue Jan 22, 2019 7:57 pm
by BoLorentzen
Sooo.. this is puzzling me,

I have no problems removing and swapping filament, when clicking tor extrude the nozzle heat to working temperature.. then extrude.. perfect.

But when sending a print job. the bed start heating but the nozzle remains cold????

Bo

Re: Nozzle not heating on prints - but can extrude in the tool box

Posted: Wed Jan 23, 2019 8:27 am
by Owen Sparks aka Marksman
Do you have the preheat option turned on? If so the bed will heat for 15minutes before the nozzle heats up and the print begins.
Owen S