Nozzle not heating on prints - but can extrude in the tool box

Share your experience with UP mni 2!
Post Reply
BoLorentzen
Posts: 1
Joined: Tue Jan 22, 2019 7:55 pm

Nozzle not heating on prints - but can extrude in the tool box

Post by BoLorentzen » Tue Jan 22, 2019 7:57 pm

Sooo.. this is puzzling me,

I have no problems removing and swapping filament, when clicking tor extrude the nozzle heat to working temperature.. then extrude.. perfect.

But when sending a print job. the bed start heating but the nozzle remains cold????

Bo

Owen Sparks aka Marksman
Posts: 609
Joined: Tue Mar 15, 2016 9:56 am

Re: Nozzle not heating on prints - but can extrude in the tool box

Post by Owen Sparks aka Marksman » Wed Jan 23, 2019 8:27 am

Do you have the preheat option turned on? If so the bed will heat for 15minutes before the nozzle heats up and the print begins.
Owen S

Post Reply